Racka RGC2 Controller ID Guide

1. Locate the controller

The controller on the Racka RGC2 is accessed from the rear of the vehicle and is mounted on the underside, just forward of the rear axle.

  

2. Observe & Identify The Controller

From the rear of the vehicle you will be able to identify the controller. The controller in this model vehicle (2024) is the FJ 400A.

 

3. Locate & Identify Programming Port

To locate and access the programming port you need to lift the seat to the battery bay, from the drivers side it will be between the battery and the side of the vehicle.

 

4. Locate Programming Port

The programming port on the Racka golf cart is a 4 pin black flat automotive style connector with 3 wires.

  

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

5. Programming Cable

To establish a connection with the FJ controller in your Racka golf cart you will need to use CartCables part # CC-CBL-FJSE. It can be purchased HERE

 

6. Programming Software

In addition to the programming cable you will need to have a copy of the "FJ Programming Tool" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

 

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.