Alpha EV Legacy Controller ID Guide

1. Locate the controller

x

The controller on the Legacy model is located under the seat in the battery bay on the passenger side of the cart. It is mounted in a black protective box with the tow/run switch mounted to the cover.

 

2. Access the controller

x

To access the controller you will need to remove the cover from the controller box. With the cover removed, you can easily see the controller.

 

3. Observe & Identify The Controller

x

With the cover removed we can easily see and identify the controller.

 

4. Locate & Identify Programming Port

x

The programming port on the Legacy is located close to the controller, once you locate it you can probably access it without having to remove the controller cover each time. It is a white 4 pin connector.

 

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

5. Programming Cable - Curtis Controller

To establish a connection with the Curtis controller in your Legacy cart you will need to use CartCables part # CC-CBL-1309. It can be purchased HERE

 

6. Programming Software - Curtis Controller

In addition to the programming cable you will need to have a copy of the "Curtis 1314 PC Programming Station" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.